UltraClear Super Strength Treatment - SST 1 Gal

UltraClearŪ Super Strength Treatment is designed for clarifying ponds with severe water quality issues. Mats of long filaments and scum that float on the pond surface are the source of pond clarity problems. These mats often break apart quite easily, which means that they may sometimes be difficult to remove with a net. Break-up and decay also causes undesirable suspended solids that can't be easily removed from the water. UltraClearŪ SST is enriched with several types of beneficial, safe, non-pathogenic bacteria. These natural clarifiers consume nutrients that cause undesirable growth, attacking cloudy water at the source! UltraClearŪ SST contains the following:

• Bacillus amyloliquefaciens, which degrades starches and carbohydrates
• Bacillus subtilis, which degrades starches, proteins, and fats
• Bacillus licheniformis, which converts nitrate to nitrogen gas
• Cellulomonas biazotea, which digests cellulose

Dosage Instructions

The dosage of UltraClear SST is based on the volume of water in pond. Generally, use 1 ounce for every 150 gallons of pond water.

The required frequency of product dosing will vary between once per week to once per month in most cases. If you are simply trying to prevent a problem that seems to occur each year, start dosing UltraClear SST before you have a problem, and repeat once a month during those months when you have normally experienced blooms.or growth in your pond.

If you are treating an existing problem, dose once a week until the problem is solved, then revert to dosing monthly or as needed.

For severe problems, dose daily until the pond shows improvement. That will mean that you observe a brownish look associated with decay. At this time, switch to once a week dosing. Then continue until the problem is solved, at which time you may revert to the standard monthly doses, or as needed.

You cannot harm your pond by overdosing. But remember that all biological solutions take more time to show results than would chemical techniques. By following the above dosage guidelines, you will achieve the best mix of rapid results without wasting product.

For best results, mix the required dose of UltraClear SST into a gallon of pond water, shake or mix well, then distribute the mixture around the pond. Put most of the product in the areas where you have a problem. Apply greater amounts of the product directly to areas where the problem in the worst.